Give dealer a call or stop by and look at one on the lot.

 

Welcome to the forum. Are the gears switched electronically? I wonder of the gear selection is only indicated at the control lever and the green "N" light is only lit to show you that the tractor is in neutral to allow the engine to start.
Maybe a Kioti owner with a similar unit can chime in.

 

I have a Kioti NX 5010. When I switch between ranges L M H they are lit up on my dash. What does your owner manual say.

 

Almost positive that you are not going to have any indication of the gear you are in. Neutral is shown as it is a pre-requisite for starting (and tractor exit when running). After just a few hours of use/familiarity with your tractor - you'll know what gear it's in without needing to have an indication.

 

I have a 2021 CK3510 SE HST, which is what I am assuming you have, mine is the same way....It only shows the "N" for prestart.......I am not sure why this is an issue since all you have to do is look down at the shift lever to see what you have it in......

 

This is on my NX. Probably different for other models

 

My 2021 CX doesn't have much in the way of dash lights, either. I'm always driving off with the parking brake still on. duh Annoying. Or -- Maybe I just can't see the dash light or don't pay attention or because it's an open station, the Sun washes it out. I guess I just need to pay attention better.

 

They don't light up on your model. The same dash is used for several models.

 

Hey Doug,
I'm having the same issue with the same model. I'd call the dealer, but that is a story in itself. Did you ever figure it out? On start, all the pretty lights come on and seems to pass system checks...runs and operates fine. But no neutral/gear/4x4/etc lamps display during operation. I also have a Kioti UTV with super similar cluster and those lamps operate, so weird.

 

I just recently bought a 2024 CK2620 and the neutral light only comes on when you first turn the key on. The 4x4 light was the same way, but I was able to add a switch and run a wire to the cluster and now the 4x4 light works. I might try to figure out the neutral light later. It seems stupid for Kioti to have the lights but not make them work.