[deereflugel]

Need Model 130232, Type 4036.1, Code 89092507 or its equal replacement that matches the bolt hole pattern for An EZE vac impeller from a lawn vaccum. I believe the shaft is 2.5" by 5/8" diameter, and is tapped and threaded. Need now. Leaves are falling at a rapid rate, present engine threw a rod.

 

[SuperFreak]

i have a briggs vangard presently on a pressure washer runs great. since it was on a pressure washer it has little use. Abut 5 years old ill take $100. Starts on 1st pull.Has low oil alert also.

 

[Chipmaker]

Does that engine have an extremely short crank end? I found a bunch of super prices on engines thatw ere built for use on pressure washers (direct couple) but all of them had crank ends of about 1 3/16" OAL from the oil seal face. Prices were super at $80.00 for a 6.5 hp OHV B & S Intek, short of the crank if I had more than one of them in use I wuld buy one for spare parts.