Tractor Forum banner

Transmission adjustment

2035 Views 4 Replies 3 Participants Last post by  Ingersoll444
I made a brake adjustment a few weeks back on my brakes for my older LT1000. After a couple of days, I hit the brake/clutch and it would hang up. Only way to get it going again was to push the brake/clutch toward the driver. It would then pop back into gear. My question is,

If I tightened the adjustment nut too tight, could it cause this to happen. Has anyone else had this happen to them?

Just curious. I haven't had time to sit back and look at it (been too busy playing with my new toys!!!). Any feedback would be appreciated.
1 - 2 of 5 Posts
Been there, done that. Thats always my first line of attack, Lube it up.

I think it is the nut, but I am just curious if anyone else has had this type of issue.
1 - 2 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.