Tractor Forum banner

Transmission adjustment

2035 Views 4 Replies 3 Participants Last post by  Ingersoll444
I made a brake adjustment a few weeks back on my brakes for my older LT1000. After a couple of days, I hit the brake/clutch and it would hang up. Only way to get it going again was to push the brake/clutch toward the driver. It would then pop back into gear. My question is,

If I tightened the adjustment nut too tight, could it cause this to happen. Has anyone else had this happen to them?

Just curious. I haven't had time to sit back and look at it (been too busy playing with my new toys!!!). Any feedback would be appreciated.
1 - 2 of 5 Posts

Spray some oil on the arm and all pivot points that works the brake and see if that helps.

Is there some kind of spring that pulls it back maybe its sprung or missing.
1 - 2 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.