Tractor Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
I believe it was in June that I made a post about replacing the crankshaft pulley. Andy asked me if I had taken any pics of my project. Well here are a couple of "while your at it pics" While I had the front end off, I decedide to rebuild the axel assembly, kingpin and bushings. This winter I will take it back down and do a rebuild on the engine. A little bit at a time.
Thanks,
Dove
 

Attachments

·
Registered
Joined
·
13 Posts
Discussion Starter #4
Had it torn apart. I couldn't see putting it back together like it was. I wanted it to work some more before winter. Don't figure I will mess it up too bad on the rebuild.
Besides, I'm just retired and didn't have a lot else to do this summer.
Regards,
Dove
 

·
EX Super Mod
Joined
·
5,317 Posts
Sure is purdee nice job Dove:thumbsup:
 

·
Registered
Joined
·
26 Posts
Real nice paint job......... To bad you have to do the engine all over again. I noticed the non-OEM compy seat. Enjoy your retirement!
 
1 - 6 of 6 Posts
Top