Tractor Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Just wanted to say High. I been around tractors all my life. Repair a lot of them. Never own a farm but work for many farmers. Retire now. Bought a older Kubota B6000. I had for it years. PTO goes in opposite direction, That PTO unit that corrects that is very expensive and hard to come by. I like to put a bucket on it but from what little data I found not enough to attempt that project. Right now my rear rim rusted out real bad, I would weld it but to far gone. Cant buy a new one Kubota dont carry them no more had no luck find a use one. There was a salvage yard in Kentucky but I think it went out of business. The rim on the b6000 is different than other rims in later years is what I been told. I tried a rim that was newer by about 5 years and it would not fit. so right it sats until a come up with a solution. So once again hello everybody. .
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #5 ·

·
Registered
Joined
·
3 Posts
If the center is solid I would look at having the outer part of the rim replaced with a donor rim ,often done up here on larger equipment
 
1 - 7 of 7 Posts
Top