Tractor Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
So I was brush hogging with my John Deere 606 rotary cutter and my slip clutch came off and now I can’t get it and the holder to stay on the splined driver shaft. Does anyone know or have advice on how to fix this issue? I attached some pictures of my problem. Any help is greatly appreciated!
 

Attachments

·
Registered
Joined
·
568 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
Thank you for the info. Yes the grease fitting is still on my slip clutch. Is there any certain way to replace those balls or just put them in the recessed part of the slip clutch along with grease?
 

·
Registered
Joined
·
568 Posts
As I stated previously I'm guessing ball is used as the SC to shaft retainer. I suggest to remove grease fitting & then slide SC on gearbox input shaft to see if a depression in GB shaft aligns with grease fitting orifice.
 
1 - 7 of 7 Posts
Top