Tractor Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I replaced the two big O-rings on both ends and replaced the "cup leather"- I still have the "Wiper Seal" and a smaller O-ring that is supposed to go on the rod end of the cylinder. I can't figure out how to uninstall the old ones to put these in! Anyone have any advice? There are what appear to be big roll-pins holding the cylinder heads to the piston rod but I don't know how or if they come out
 
1 - 3 of 3 Posts
Top