Tractor Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
47 Posts
Discussion Starter #1
My 22 leaks a lot at the input shaft to the transmission. I have the drive shaft out and have taken the bolts out of the housing that surrounds the input / spline shaft. The housing rotates around the spline, but wont come off of the spline shaft.

There is a large nut about 1 1/2 or so that is around the spline. It was dimpled around the spline shaft in a couple of places. I guess this has to come off before I can get to the seal, which is in the housing.

Anybody got any tricks or suggestions for removing this nut. I would go out and buy a socket, but it would have to be very deep as the spline shaft sticks out about 3 inches or so.

thanks,

Steve
 

·
Registered
Joined
·
317 Posts
Or take a socket and cut it in half then weld a piece of pipe between the two halves.
:D Al
 
1 - 3 of 3 Posts
Top