Tractor Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
My inside brake hangs up on release. It doesn't release all the way from the geared cam under the floor board that holds it in place when engaged.
I can lie on the ground and pry it over to release but this is a 2 person job as someone needs to press down on the pedal while I'm on the ground.
Any suggestion would be appreciated.
 

·
Premium Member
Joined
·
2,675 Posts
Should be a spring on the cam that keeps it disengaged unless the lock lever is activated.

Remove the cam and look for the spring remains, clean the rust off the pivot, then lube the pivot with a dry lube when new spring is installed.
 
1 - 3 of 3 Posts
Top