Tractor Forum banner

Easiest way to work on LT/GTs?

3436 Views 11 Replies 9 Participants Last post by  Ed_GT5000
What is the preferred way of working on a common LT/GT?
I have 2 Craftsmans (see other GT5000) post --- and I never felt comfortable climbing on the ground and wedging something under the deck to change blades, do undercarriage maintainance, etc... Any easier way? Ramps that bring the whole unit up safety, jacks, etc? Seems like someone should have some really good ideas on this topic. I may be way off here, but I never have had an easy time working on these things. I am handy --- I do full-size tractor restorations and engine rebuilds for cars/trucks etc --- but they are slightly higher off of the ground and dont have any blades --- :)

Thanks for any insight.

Andy
1 - 1 of 12 Posts
Just saw one of these when I was out shopping yesterday. Would come in REAL handy working on L&G stuff.

jack



I will have to grab one when the Christmas rush is over.
1 - 1 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top