Tractor Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hello, Just found this site and can't seem to get off of it. Just joined a few minutes ago.
My 1952 8n was burning oil pretty bad so I thought I would take it apart & rebuild the engine. Now, my tractor is scattered in the barn with the block on the engine stand. I've been a truck mecanic my entire life but I need help with the cylinder sleeves. I have a sleeve puller, so how much hassel is it to replace the sleeves my self? The serial number is 8N465860 with a diamond behind the number which (through investigating) is suppose to have cast iron sleeves. Any help would be appreciated.
Thanks, Jim
 
1 - 2 of 2 Posts
Top