Tractor Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I have an old sears 10hp tecumseh rider. 917.255726. I need to know what wires go where on the 5 prong starter switch. Looks like someone rewired it and I would like to put back to original.
TIA
Sam
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #2 ·
thanks for the info MGM. I was hoping there was a pretty much standard schematic for 5 prong ignitions. the new ignition has letters on it next to each prong. W?M,S,L,B,+G. I should probably get the manual but not sure the thing will even run. I just wanted to fire it up and see what it sounds like. Guy that gave it to me said was knocking before he used the switch for another tractor.
 

·
Registered
Joined
·
207 Posts
rutlandsam
M=Magneto, S=Starter Solenoid, I=Ignition, A=Accessory, B=Battery, G=Ground, L=Lights, R=Regulator-Rectifier
Most switches have letters on the prongs themselves or stamped in the back on the plastic. Hope it runs.Good Luck
 
1 - 4 of 4 Posts
Top