Tractor Forum banner
1 - 15 of 15 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi!
I need to fins the cav pump governor spring position code for cav pump with dpa number 3233F641.

anyone?
Thanks

Svenn
 

·
Registered
Joined
·
5 Posts
Spring code 5..
2&2.. good luck
dear sire I have a MF 150 tractor. 3cylinder diesel perkins.
Spring code 5..
2&2.. good luck
Dear Sir,
I have a MF 150 tractor. 3 cylinder Perkins diesel. CAV-DPA serial Number pump-3230240. I need the governor code as well as how to read the code. I paid a person to reseal the pump and they did not set up the governor spring correctly. I can not even reach PTO speed. Thanks for all your help;. curt
 

·
Premium Member
Joined
·
1,637 Posts
My spec sheet says the pump is “coded”.. which means the spring code is stamped on the name plate..
On the last line of the name plate it should read.. the fuel, the rpm, the spring code, then the max rpm..
If its not there.. use code 6..
Which is middle hole on the governor plate..(tomb stone)
And the 3rd hole on the throttle shaft..
Which is the last hole closest to the pivot..
The throttle link MUST GO THRU THE CENTER OF THE SPRING when hooked up.!!
Go get your money back and send it to me..
Good luck
 

·
Registered
Joined
·
5 Posts
My spec sheet says the pump is “coded”.. which means the spring code is stamped on the name plate..
On the last line of the name plate it should read.. the fuel, the rpm, the spring code, then the max rpm..
If its not there.. use code 6..
Which is middle hole on the governor plate..(tomb stone)
And the 3rd hole on the throttle shaft..
Which is the last hole closest to the pivot..
The throttle link MUST GO THRU THE CENTER OF THE SPRING when hooked up.!!
Go get your money back and send it to me..
Good luck
Thanks for the information. I got it done. Could you post the spec sheet for me. Thanks again for your help. MF runs great now!
 

·
Registered
Joined
·
5 Posts
Thanks. I followed your information. Pump and tractor are working great now!! Thanks
I am thinking of installing remote hydraulics on the tractor. MF 150. What are thoughts on this. Do you happen to know the flow rate this tractor produces? Thanks again for your help.
 

·
Premium Member
Joined
·
1,637 Posts
Sorry friend, all I do are injection pumps, injectors and the occasional turbo..
 

·
Registered
Joined
·
804 Posts
Thanks. I followed your information. Pump and tractor are working great now!! Thanks
I am thinking of installing remote hydraulics on the tractor. MF 150. What are thoughts on this. Do you happen to know the flow rate this tractor produces? Thanks again for your help.

4.8 GPM.......All the specs are in the link below.....


 
1 - 15 of 15 Posts
Top