Tractor Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Please can someone give me some advise
I have a 4450 quad range in workshop done clutch packs hi and low all new seals and presure rings
I engage forward or reverse its hints forward and then stands still as soon as i apply the brake pedal it drives forward but obviously cuts the engine because brake is being applied
 

·
Premium Member
Joined
·
3,629 Posts
The clutch packs are actuated by hydraulic pressure. Put gauge on the clutch pressure port, should have something like 160-180 psi. The troublesome thing with your post is that the brakes are apparently pressuring the clutch packs??
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top