Tractor Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi everybody!
I have a question: on a 1953 Ford jubilee, when the three-point hitch piston is overextended, how do you fix it? It is stuck in the up position, how do you get the piston back in?
Thanks for any input!
Claudia
 

·
Registered
Joined
·
89 Posts
Hi everybody!
I have a question: on a 1953 Ford jubilee, when the three-point hitch piston is overextended, how do you fix it? It is stuck in the up position, how do you get the piston back in?
Thanks for any input!
Claudia
You will probably have to pull the top off of the rear end. Once your that far, you might as well rebuild the lift. A rebuild kit isn’t too expensive. Type in “NAA 3 point hitch rebuild” in videos. There are some very good videos on you tube that go over the hydraulic systems of these tractors.
 
1 - 3 of 3 Posts
Top