Hi guys looking to see if anyone has info relating to a couple things , the ECU in a case cvx 130 I bought had been stolen and I have sourced a replacement unit correct part numbers but from a CVX 150 I am guessing it wont operate the 130 until the software is updated and setup for the 130 is this correct,
I also found a bit of information about the machine in the past it had a EEM to FMGR can fault
I understand that this would mean there was an issue with the original unit , what might cause the issues, I have been told its a common thing with these Case machines.
Also has anyone tried to use any aftermarket systems to run the machines just a thought
shall look forward to your replies regards Tommy
I also found a bit of information about the machine in the past it had a EEM to FMGR can fault
I understand that this would mean there was an issue with the original unit , what might cause the issues, I have been told its a common thing with these Case machines.
Also has anyone tried to use any aftermarket systems to run the machines just a thought
shall look forward to your replies regards Tommy