I NEED the tie bar/drag link for my
1720 Ford Tractor. I bent mine
Real bad.
The metal bar that keeps the front
Wheels parallel.
Thanks
1720 Ford Tractor. I bent mine
Real bad.
The metal bar that keeps the front
Wheels parallel.
Thanks
Joined
·
3,952 Posts
Have a look at the attached parts diagram. Is your tractor a 4WD or 2WD. Power steering?
New Holland 1720 - 3 CYL COMPACT TRACTOR 20 SERIES(01/87 - 04/02) Parts
New Holland 1720 - 3 CYL COMPACT TRACTOR 20 SERIES(01/87 - 04/02) Parts
www.messicks.com
Below is a listing of 23 each 1720's listed in salvage:
Joined
·
14 Posts
Joined
·
14 Posts
4WD And power steering.Have a look at the attached parts diagram. Is your tractor a 4WD or 2WD. Power steering?
____New Holland 1720 - 3 CYL COMPACT TRACTOR 20 SERIES(01/87 - 04/02) Parts
New Holland 1720 - 3 CYL COMPACT TRACTOR 20 SERIES(01/87 - 04/02) Partswww.messicks.com
Below is a listing of 23 each 1720's listed in salvage:
Thanks for the info
Joined
·
14 Posts
Joined
·
14 Posts
Have you considered taking it off, straighting it out and taking to a machine shop and have them replace the bend pipe. Or just straight it out and weld in supports parallel to the bend? It may not be pretty but would work just as well.
Joined
·
14 Posts
Awesome PossumHave a look at the attached parts diagram. Is your tractor a 4WD or 2WD. Power steering?
____New Holland 1720 - 3 CYL COMPACT TRACTOR 20 SERIES(01/87 - 04/02) Parts
New Holland 1720 - 3 CYL COMPACT TRACTOR 20 SERIES(01/87 - 04/02) Partswww.messicks.com
Below is a listing of 23 each 1720's listed in salvage:
HEY thanks. Yes that's what I'm going
To do. It's monsooning right now
Thanks
Johnboy
Joined
·
14 Posts
BAD BEND your choices , new if available not too costly, used , blacksmith with forge, or blacksmith make new one, cut at bend ,weld together brace with angle iron on both sides ,proper thickness and size. heavy duty press and large rosebud tip torch with big tanks and gauges. Cut bend out then add same diameter or larger
rod clamp and weld together..When you reinstall check your toe in. blacksmith can make stronger=thicker.
Use heavy tube instead rod ,put existing rod in tube. GOOD LUCK .
rod clamp and weld together..When you reinstall check your toe in. blacksmith can make stronger=thicker.
Use heavy tube instead rod ,put existing rod in tube. GOOD LUCK .
Joined
·
24 Posts
I used a threaded rod, pipe, a couple nuts, and ball joints to make one. It sems to hold up fine
1 - 11 of 11 Posts
Join the discussion
