Tractor Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I fired up my 1050 yesterday and left it idle a few minutes, and saw oil dripping from behind the PTO drive pulley. My question is there a crankshaft seal/bearing that is bad ( I would assume) If so where can I locate one? I only live 15 minutes from Rays mower Shop. Thanks for any help
Brian :mad:
 

·
Registered
Joined
·
2,687 Posts
Brian

There are 2 oil seals. One on each end of the crank. Both are the same, part # PH-529. Refernce # 171 in the exploded diagram on pg 27 and pg 30 in the TRA-10D/TR-10D engine manual.

I think Ray's might have it.
 
1 - 3 of 3 Posts
Top