Tractor Forum banner

tractor

  1. Massey Harris-Ferguson
    Hello! Having lived on my 5 acre mostly wooded lot for the last 12 years, I figured it was about time I invested in a tractor to help be a bit more efficient. I'm somewhat mechanically inclined, am able to diagnose and fix most problems that come up with the dirt bikes and daily drivers...
  2. Repair & Technical Discussion
    I have a roosa master dbgvcc429-4c, from a 1962 Ford 4000 tractor 4 cylinder, I am rebuilding the pump and in the process I took the cam gear off to clean it and forgot to take a picture of which direction that I was pointing does it go back on clockwise or counterclockwise thanks
  3. Repair & Technical Discussion
    I recently got a Ford 5000 tractor, it had been sitting for 7 years. Had problems with clutch, but now working. PTO runs for about 10 minutes then quits from a cold start. PTO won't work again until the next day. Any ideas or suggestions would be appreciated.
  4. Classifieds
    I am looking to sell a bunch of Ford tractor parts I have collected over the years. All are for the 1965-83 2/3/4000 and 1976-83 26/36/4600 three cylinder models. Engine blocks, cranks, heads, some tin, lights, lots of misc stuff. Have some New pistons for 4000 gassers and some new ones for 3000...
  5. Repair & Technical Discussion
    Hi I have a David Brown tractor 880 Selectematic mid to late 60's The 3 point linkage will not lift if the tractor is pointing down hill at all, even on a slight slope. I've had a suggestion from a person on the forum that the tractor may possibly have the wrong transmission dipstick hence the...
  6. Repair & Technical Discussion
    I have a 1954 Ford Jubilee. I was using it to pull some small stumps out of the ground. The stump I was pulling on was around 6 inches in diameter. When I pulled on it I heard a load pop. Now the tractor will not move. Cranked it up and looked inside of the transmission cover and all seams to be...
  7. Repair & Technical Discussion
    I recently bought a 1979 995 Case Tractor and do not have a manual for it. I need to know how to change a stuck valve in the rear hydraulic lift system.
  8. Repair & Technical Discussion
    Recently found on my property. Some remnants of red paint visible on inside. I have seen similar grills on some tracked tractors. Anybody have a clue to what is off of?
  9. Tractor Photos
    Last month I bought a 1958 Fordson Dexta. It's in pretty good shape overall. I had to replace the wiring loom because some wires were in pretty bad shape. This turned out to be a bit of a challenge as the diagram that came with the wires was inconclusive. The original 1958 diagram and some...
  10. Kubota
    Hey we own a Kubota b2150 which seems to have a issue with the the rear hydraulics, the hydraulic arms seem to just stay up and don't seem to budge, any recommendations?
  11. Operating & General Discussion
    Hi everyone, I'm a student at the University of Buffalo and I am doing a student research project on how people use diesel exhaust fluid (DEF). I want to hear about your experiences because the people who use it every day should have their voices heard. If you guys could answer my questions...
  12. Repair & Technical Discussion
    Hi everyone, I'm a student at the University of Buffalo and I am doing a student research project on how people use diesel exhaust fluid (DEF). I want to hear about your experiences because the people who use it every day should have their voices heard. If you guys could answer my questions...
  13. Repair & Technical Discussion
    I have a 2006 Task Master 425 tractor, with a diesel 385 3 cylinder motor. I am looking to replace the starter, but I have no idea how to determine what model of starter would be compatible or where I could possibly purchase one anywhere. Any insight or advice would be greatly appreciated! Thanks!
  14. Attachments, Implements & Accessories
    I tried the Tractor Supply Co. subsoiler but no joy. see what happened in my short video. at least they took it back with no hassles. have a different aftermarket one on order
  15. Case / Farmall - International Harvester
    I am new to Case tractors. I am currently looking at one for sale. I have not seen it in person these are the only photos I was sent. Could someone please help me with some info. I was looking for model, year, etc. I would also like to what I should pay for this tractor. It doesn't run but was...
  16. Operating & General Discussion
    I have been looking to buy a smaller tractor that I could mow with and do some light farm work with. I have seen a-lot of Kubota 2370s', BX25s' and John deer 1023s', 1025s' all with low hours and look almost new. I'm thinking that someone bought them thinking they would do the job but turned...
  17. Operating & General Discussion
    My 1030 is finally getting off to a start following things which meant it had to be put on the back burner for a good portion of 2019. For those who don’t know, this was gifted to me by my grandfather. When this arrived to my work area, it was running well and still does, but developed a...
  18. Attachments, Implements & Accessories
    I have a 1969 Ford 4000 Diesel tractor that has 38" spin out rims which gives me a 6 to 7 foot width. I want a rototiller but a seven foot tiller new cost over 2500 and a used 4 to 5 foot tiller run about 800. What are your thoughts. I am not looking to do acres and acres of tilling just a few...
  19. Classifieds
    1986 Ford 445A tractor in great shape. Low hours with 6' blade and bucket loader.
  20. Repair & Technical Discussion
    Hello, I traded for a cool little Satoh Elk 550G a couple weeks ago. When I went and looked at it it started and ran fine. I got it home and drove it around my place for a few days with zero issues. The other day I went out to start it and it would not start. Battery is Great, I have Spark at...
Top