Tractor Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-14 of 14 Results
  1. Attachments, Implements & Accessories
    Hello all. Retired Californian living in Portugal, enjoying my first (subcompact) tractor!! I need your help please. My tractor is a Yanmar F145d (4wd, 14.5hp at PTO, only 870 hours total). It is a gray-market tractor (both in Europe where I live and also the USA). It came with a tiller...
  2. Attachments, Implements & Accessories
    I currently have a old 48” tiller that works great. As I was looking the tiller over I realized there is no slip clutch or shear pin. I am hesitant to run the tiller because I don’t want to mess up anything on the pto side of the tractor. Is it possible to add a shear pin or slip clutch and also...
  3. MTD
    Would someone have some time to take a look at photos I have of my Yard Machine (I think 390) tiller and tell me how to put it back together? My ex stole parts off of all my tools and belongings to make them unusable. I tried to go by the manual I found online, but something seems a little...
  4. Troy-Bilt
    Hello, New member with first post. Just picked me up a brand new 1971 Horse (SN 20480) that is in great condition for its age. Just going through it and changing all the maintenance necessities but am a bit stumped when it comes to the rear tine gear oil. Every manual and thread I can find says...
  5. Troy-Bilt
    I have an older 80s Troy Built tiller that the starter wont engage. Starter Spins freely and strongly but clutch doesn't seem to allow the gear to engage? Cant find engine or tiller part/ model number anywhere so in the dark here. See the video the clutch seems to be sticking . So the...
  6. Attachments, Implements & Accessories
    I have a 1969 Ford 4000 Diesel tractor that has 38" spin out rims which gives me a 6 to 7 foot width. I want a rototiller but a seven foot tiller new cost over 2500 and a used 4 to 5 foot tiller run about 800. What are your thoughts. I am not looking to do acres and acres of tilling just a few...
  7. Troy-Bilt
    Hello all. I have a 1980 vintage Troy-Bilt Horse rototiller, 6 HP Tecumseh, with less than 100 hrs. This vintage does not have the PTO dis/engage, so tines are live when in Forward or Reverse. The tiller is in Low Speed range. I am unable to shift the speed lever from Low to High range. Any...
  8. Classifieds
    I have an Ariens S16h, tiller, snowblower, mower deck and front blade. Tractor hasn't run in a couple years (some electrical issue). ran fine, but doesn't click or anything now. Tiller, blade, snowblower are all fine. I've never used the deck... it has a few rust holes and has been patched...
  9. Repair & Technical Discussion
    I need to turn over my garden so I pulled out my 1+ year old Troy-bilt 24” garden tiller and it wouldn’t fire. Drained gas and added new gas plus fuel treatment. Not firing. Sprayed ether into the carb and it fired off but would not continue running. The push to prime rubber piece has a hole in...
  10. Crops & Garden
    Hi ! Newbie farmer here :) We just purchased 25 acres. We also purchased a Ford 1700 I also purchased an agrotiller. It's a big 5 footer requiring about 35 hp. My tractor is small and suited for about 23 hp. My question is Can I remove some of the tines to cause it to require less hp ? Thanks...
  11. Long / Farmtrac / Montana/ LS
    Well, I got to try my new Titan Implement 4ft Tiller in the garden. This thing is a beast. The LS MT125 did a great job pulling it. I am so ready to start planting. Here is the video.
  12. Attachments, Implements & Accessories
    I am thanking about getting a rotary tiller for my Ford 4000 diesel and want to make sure I get a good one and need your help once again. I have about 15 acres of weed eaten rock embedded clay soil that I want to transform into a hay field and/or vegetable plots. It had rotary cutters used on...
  13. Long / Farmtrac / Montana/ LS
    Good Morning, I thought I would share a video of my LS MT125 Tractor tilling my garden for the winter. I put down 10-10-10 fertilizer and tilled it in for the winter. My LS MT125 is very strong in this task, and I sure had a good time doing it.
  14. Repair & Technical Discussion
    Hello, I have a 31cc MDT Yard Machines front tine tiller. The flexible drive shaft snapped off. I can buy a replacement but I can't figure out how to remove the old one. Do I need to open the gear box? If so, how does the tine bar release? Thanks in advance!
1-14 of 14 Results
Top