Tractor Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Repair & Technical Discussion
    I have a roosa master dbgvcc429-4c, from a 1962 Ford 4000 tractor 4 cylinder, I am rebuilding the pump and in the process I took the cam gear off to clean it and forgot to take a picture of which direction that I was pointing does it go back on clockwise or counterclockwise thanks
  2. Operating & General Discussion
    Hello all ! I finally picked up my grandfathers Gutbrod at the weekend which I was worried would be seized and derelict. After getting it out of the storage and onto the trailer by pushing it, I had a little more faith to know the steering column and wheels all worked as they should with no...
  3. Repair & Technical Discussion
    All, Having fuel leakage and low pressure issues with my Belarus 310. Does anyone have a link to a HOWTO to refurbish the primary and the secondary fuel pumps for my tractor. I ordered new hand primer pump and the two fuel filters for it. Is there a gasket/seals kit for my 2 pumps? If so...
  4. Ford / New Holland
    Guys, I am in the process of re-assembly on my 72 Ford 3000 gas engine rebuild and should have taken more notes LOL. I did not plan on the shop taking as long as it did however I have my block back with new pistons, crank, cam, ect and have the crank installed and the cam in place with the...
  5. Repair & Technical Discussion
    Guys, I am new to opening up a tractor but I understand the technical aspects and do enjoy working on them. I have a 72 Ford 3000 Gas engine that was knocking when at an idle (low end) and started knocking toward the top end as well. I have just purchased the tractor so don't have much history...
  6. Case / Farmall - International Harvester
    My Super C is down for a rebuild. New pistons and sleeves. :)
1-6 of 6 Results