Tractor Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. John Deere
    I just purchased a John Deere 1050 with a blown head gasket. The tractor ran and I drove it into my shop for the repair. After installing a new head, gaskets, ect, I am having an issue with getting it to run. I have gone through the bleed process several times and I cannot get any fuel to the...
  2. Ford / New Holland
    Worked this 2120 hard for two straight weekends. Parked it in the woods, got rained on and now won’t start. The instrument cluster is acting weird; turns on for the first ignition turn, but no crank just a thud sound (fuel filter?) and then the instrument cluster turns off... after a minute or...
  3. John Deere
    My 1993 JD 445 is not getting fuel at all. It has been parked for about 10 years and not used. I recently pulled it out of the barn to put it back in service. Cleaned battery terminals and installed new battery. Removed fuel pump from tank, replaced filter screen on pump, removed and cleaned...
  4. Murray
    I have a Murray 40504x92A that ran once this year and the next week I got nothing. I have charged the battery, replaced spark plug, checked the ground wire, replaced seat switch, solenoid, ignition switch, PTO switch, clutch/brake switch, fuse checks out as does spark plug boot and wire,air...
  5. John Deere
    Older jd dt150 mower. Runs fine while gas that i poured in crab is there. Gas has been replaced and gets to the float/bowl without issues and filter is new. Any ideas why the gas wont travel from the float/bowl into the cylinder to be fired upon?
1-5 of 5 Results
Top