Tractor Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. Simplicity
    Just picked up a Simplicity Sovereign 7016, model number 1690427 01485. Got is as a project for cheap under the impression it needed less work than it does. No biggie but I'm having a hard time wrapping my head around the vintage ignition system and was hoping for some assistance. As it sits...
  2. Craftsman / Sears
    Tractor is mid 90's I believe and only use this for plowing as it doesnt have a mowing deck. Worked fine last season but I cant get it to turn over now. It cranks, but thats it. I emptied the old gas/replaced w/ new, replaced the relay and spark plug, as well as clean some rust off the...
  3. Repair & Technical Discussion
    I have a 1948 Farmall H that i got running, I drove it for about 20 minutes, I shut it off and now there is no click and no cranking. Any suggestions on moving forward? I have a brand new battery and it's fully charged. I have put in a new push start switch and a new cut off switch. Before i got...
  4. Husqvarna
    Hi, I've got a Husqvarna LGT2654 that won't Fire. I got it from a family member for free and trying to get it work. So far, its had a tune up but won't fire, does crank. Does get gas to carb too. Would the Vent Line from the tank, stop it from fireing? Any help much appreciated. Now it...
  5. Ford 9N/2N/8N
    My 1941 9N was running fine this week until I changed the water pump because the belt was squealing and radiator overheating. After putting everything back together, the tractor cranks but no spark. Pulled plugs and made sure they were dry. Have plenty of fuel. It even runs out of the carburetor...
  6. Repair & Technical Discussion
    Cannot start my STX30 Deere lawn tractor. I am getting gas to carburetor but no spark. Actually shows spark on plug tester light but not when looking at the plug (yes plug is grounded). Maybe weak spark. Will not turn over with starting fluid in carb or cylinder. Replaced the magneto, starter...
  7. Projects
    Well, as the titel says I’m having problems with the ignition on my Massey Ferguson 350 or MF35, I cannot get any spark from the distributor or ignition coil. I have tried to just connect the coil to the battery and open the breakerpoints by hand, still nothing, then I put the spark plug...
  8. Repair & Technical Discussion
    I have a ford 9N/2N with the front mount Distributor. I was lazily Brush Hogging when it lost power and it died. I checked for spark, it had none. I replaced the Coil, Distributor Plate (had bad screw),Capacitor,Points,Rotor Button. When I tested the top of the coil my light is bright and...
1-8 of 8 Results
Top