Tractor Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-11 of 11 Results
  1. Massey Harris-Ferguson
    G’day, just had an MF168 pulled out the back of my shed a few hundred k’s away and brought up on a flat top. One of the FEL rams didn’t cope well at all and was pouring oil out. I bought and fitted a new one, but had to get the cleavage machined to fit into the FEL arm so it sat for a couple of...
  2. Repair & Technical Discussion
    Our Massey Ferguson 165 tractor's fuel gauge has never worked. The fuel gauge was bad but I was able to order a new one (p/n: 1074336M9) for $20 here...
  3. Repair & Technical Discussion
    hi, I bought a used MF 1428V. After getting it stuck, I realized I'm not getting power to the front. :( Before I started tearing apart a transmission (ughhh), is there anything that is a common problem?
  4. Massey Harris-Ferguson
    Hello everyone! I have a MF 711 skid steer. Starts great, runs quiet. Goes forward, backwards, no issues. Try turning side to side and..well...It feels like its binding, wont rotate around and almost stalls the engine. Fluids are clean and filled. No leaks (well, everything leaks when you are 40...
  5. Repair & Technical Discussion
    I´ve a Spanish MF267, which I had assumed was a narrow version of the MF265, with play in the steering assembly (steering column). Before I investigate further I was looking at availability of spares but the casting has ´122101F DIASA BURMAN´ with the attached steering arm 'DIASA 122591E´...
  6. Projects
    Well, as the titel says I’m having problems with the ignition on my Massey Ferguson 350 or MF35, I cannot get any spark from the distributor or ignition coil. I have tried to just connect the coil to the battery and open the breakerpoints by hand, still nothing, then I put the spark plug...
  7. Repair & Technical Discussion
    Hi there I have a mf 135, I was coming home today and parked up the tractor in the shed. When I was going out I found this piece on the ground and it is the same colour as the body of the tractor which was recently sprayed. Can someone please tell me what this is and if it is important for the...
  8. Massey Harris-Ferguson
    Hi there I have a mf 135, I was coming home today and parked up the tractor in the shed. When I was going out I found this piece on the ground and it is the same colour as the body of the tractor which was recently sprayed. Can someone please tell me what this is and if it is important for the...
  9. Massey Harris-Ferguson
    Hi everyone. I bought a 1973 Massey Ferguson 135 recently. I was told in the garage that it was not a live drive and that the 3 point linkage and the PTO could only be operated when my foot was fully off of the clutch. This leads me to believe that the tractor has only a single stage clutch. I...
  10. Repair & Technical Discussion
    Hi there. I recently bought a 1974 masseg Ferguson 135 that was restored and it's going like a clock There's only one thing I have an issue with When driving it the the tractor does not drive off until the clutch is just released at the end It makes it very difficult to drive it because there is...
  11. John Deere
    Looking for the special pto wrench tool made by MF to change out the PTO spindle from 540 to 1000. Have seen a picture - on one end the wrench has a female 1000 spline and on other end a female 540 spline with a hole in between to insert a bar for leverage. Anyone have one or know where to...
1-11 of 11 Results
Top