Tractor Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Massey Harris-Ferguson
    Hello all, I have a Massey 245 with the Perkins. Over the last couple years it has been really slow going up hill in the road gears and now it’s at a point where it wont even move at all in and high gears on flat ground. I just adjusted the clutch (through bottom cover) to the shop manual specs...
  2. Repair & Technical Discussion
    I have a Zexel injector Pump 16006 that came off a Kubota D722 motor. I am looking for a part number for the control lever. The small pin on mine broke and I can not for the life of me find anywhere on the interweb any manuals and or just the part number. If you know where I can order this part...
  3. Repair & Technical Discussion
    I made the mistake of removing the top cover like several have already done and don’t know which hole to reassemble spring/linkage. I understand there is a chart that helps decipher but I can’t decipher my numbers. They are as follows printed is “DPA” stamped “3233F661” Printed is “DSA” stamped...
  4. Kioti
    Hi All. I have just relocated the fuel pump of my CS2610 tractor from behind the engine to just forward of the LH rear wheel. This might seem a bit of a waste of time, but I have had some pump issues in recent times and it is hard to fault find something that you cannot get to easily, especially...
  5. Repair & Technical Discussion
    I have a roosa master dbgvcc429-4c, from a 1962 Ford 4000 tractor 4 cylinder, I am rebuilding the pump and in the process I took the cam gear off to clean it and forgot to take a picture of which direction that I was pointing does it go back on clockwise or counterclockwise thanks
1-5 of 5 Results
Top