Search Results for ‘hydraulic lift’

So i bought a ford 3000 as a project and i'm trying to fix some some things, the engine runs great and all but there's one problem i encountered and that is that when i start the tractor my hydraulic lifts won't go up for a couple of minutes, after waiting a bit i can use them and unless i put...

Hi, New Member here. Looking for guidance from anyone that knows tractor hydraulics. My tractor is a Ford 1910, 1986 with 770A Loader. Problem: When I start cold, both the bucket and three-point hitch will lift (though the bucket has lost lifting strength). But once the oil gets warm, both the...

I just recently replaced one of my hydraulic lines and was hoping to have the air bleed out on its own while operating with no load. Well, it didn't quite happen like that. Seems like the hydraulic oil level went too low on an incline and I got air in my circuits. I still have most of my...

I have an Allis Chalmers 160 that has no resistance on the three point lift lever. It raises and lowers but when I turn loose of the handle the 3 point drops and the lever drops to the bottom of the quadrant. I don't see anything on the outside that might allow me to tighten to add resistance to...

So I bought an Ariens s-16h this Thursday, and have been working on restoring it into working order for farmwork. I have a few main issues I do not know how to remedy, and they all deal with the hydraulics. First is the hydrostatic drive will not disengage, next is that even if I flip the little...

I just inherited a 1967 Ford 4000 3-cyl Diesel tractor with a new home. It was sent off to service just before the purchase so fluids were replaced. Everything is working well except for the three point hitch in Position Control mode. The rear implement doesn't track the position control lever...