Search Results for ‘governor’

I recently lost a push rod that went into the motor. Using a magnet to get it out I found small pieces of metal and decided I would have to take it apart to figure out what had happened. I had to replace the camshaft, the governor and push rods. I thought everything went back together okay...

Hello, I'm grasping at straws here but I was hoping that another B275 owner with a CAV rotary injection pump might be able to provide me with the "setup number" stamped on the oval plate fastened to the side of the CAV pump. I made the newbie mistake of taking the top cover off the pump to...

I have a 1979 International 284 gas tractor. I would like to know how the governor is lubricated. Specifically where to lubricate it, fill hole, drain hole, oil viscosity etc. Thank you, Herb

I recently had a water leak and had to do major disassembly to replace the hose. Upon reassembly, the engine worked fine, but there was still a leak. Disassembled again to successfully replace the water pump. Upon reassembly, no more leak, but the engine behaves as if the governor is not...

1974 4 cylinder gas tractor. Will start but has no power with governor connected. Disconnect governor and will run at high rpm. How to adjust? Just had carb professionally rebuilt. Also new gas filter and running on gas without EtOH.

Asking for some knowledgeable assistance on my Kohler CH18 engine. Installed this replacement some years ago on an ancient Yazoo 60 inch mower. Has run like a champ every year til this one. Began hesitating, surging, governor hunting, etc. It is now to the point that I can start it, but it...