Tractor Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-10 of 10 Results
  1. Repair & Technical Discussion
    Hello, I have a IH 2400A front end loader. 1972 ish. I have serial numbers for all. It died on me suddenly. I've replace points cap rotor plus wires coil fuel pump carb rebuild kit but now it is just running to rich or to lean. How can one thing starting out to be electrical end up now with...
  2. General Lawn Garden Tractor Forum
    How’s it going all! New here! Recently got a Steiner 420 with a kubota WG600-B motor. The machine has 2,801 hours.. I’m having issues when the machine is under load. It idles fine & strong! But once I start going it starts to bog out. Has anyone had any issues like this? Trying to trouble shoot...
  3. Repair & Technical Discussion
    I have a 64 Ford 4000 4 cylinder gasser I’ve been fooling with. I’m having problems with intermittent spark. I’ve replaced coil, points, rotor, plugs and wires. When the cap is off I usually only get spark between the points after letting go of the starter button. When holding a plug to the...
  4. Husqvarna
    Hi guys and gals, I got a Husqvarna Lgt2654 about 3years ago and untill now never had a problem with the Kholer command engine. At first it would die when i was mowing and it was hot, now it wont run with a load (mower engaged) on it. It will sit there and run at idle all day, but when I engage...
  5. Repair & Technical Discussion
    Hi, We inherited a 1962(3) Simplicity 725 Garden tractor. It hasn't been run in about 8 years (when my fiancee's father past away). He took great care of it and used it til the day he died. Since we finally have a house we are able to store it and use it. When we first moved it to our place...
  6. John Deere
    Older jd dt150 mower. Runs fine while gas that i poured in crab is there. Gas has been replaced and gets to the float/bowl without issues and filter is new. Any ideas why the gas wont travel from the float/bowl into the cylinder to be fired upon?
  7. John Deere
    Hello everyone! I'm new here. My grandpa has a 1 owner 1973 John Deere 4030 gas. I believe only 222 were made. John Deere specs say it's a 5.0 6 cyl gas engine. Our problem is the exhaust manifold has blew apart from age. We have welded it twice and this last time I think it's beyond repair...
  8. Repair & Technical Discussion
    I have a 1963 international 3414 loader backhoe with a 4 cylinder gas engine. I need a carburetor. Anybody got one. Will any if the carbs tractor supply sells work on it?
  9. Case / Farmall - International Harvester
    I have a very very nice 574 international gas tractor, it has 1000 original hours on it, it's been in the family since new, I now use it on my farm and just recently had all my hydraulic lines replaced, the other day I went out to use the tractor and it was dead, I've replaced the battery and it...
1-10 of 10 Results
Top