Tractor Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. John Deere
    New to forum with technical help and part #M86234 shaft w/internal Spline needed...Please! Recently used tractor for end of season tilling 1/2 acre garden. The rear PTO outlet shaft on the tractor has a retention ring with 3-steel balls that is NOW OBSOLETE! This rear spline itself has broke and...
  2. Repair & Technical Discussion
    I bought this tractor new in 2005. It has been a good tractor. I am having problems with the Screw Thdrol (part #143). It is a part that was attached to the frame via a few tack welds. The newer versions may be different. This part holds the idler pulleys that controls the tension (Bracket Asm...
  3. Repair & Technical Discussion
    Hello, I recently bought a John Deere 316 Hydro and it does not slow down when I adjust the speed. It will continue to roll until it slows to the speed it’s set at. If I need to suddenly stop, it will only stop if I put it in reverse instead of “neutral”. In addition the brake doesn’t work...
  4. Repair & Technical Discussion
    This post has moved to the Bolens category
  5. MTD
    I have a 1999 MTD model 845 garden tractor. The original B & S engine self-destructed while idling in my garage. I located a 22 hp White engine that bolted right in. The White engine runs beautiful with 1 exception. It is a Tecumseh twin with 2 carbs. I cannot get its RPM up over about 1900 with...
1-5 of 5 Results