Tractor Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Ford / New Holland
    I have a 57 Ford 800 tractor 860 that the 3 point will not lift on. The oil level is correct I pulled the top lid off and rebuilt the lift cylinder and cleaned and put a new top lid gasket on When the top lid was off I started the tractor to see if oil is coming out of the 2 tubes on the left...
  2. Repair & Technical Discussion
    Having some issues with my Ford 850 tractor - Started having issues about a month or so ago & I finally got around to tinkering. It started out where the tractor would run ok but not great for about 10-15 minutes then die followed by a very hard or no start. Now I can't get it to start at all...
  3. Repair & Technical Discussion
    does anyone know what this hole is for under the hydraulic pump it’s a little bigger than a quarter and you can see inside the engine/transmission
  4. Introductions
    Hello all! I'm new to the forum and wanted to introduce myself. I live in south-central Missouri and I own a 1957 Ford 800. Looking forward to interacting and learning from you all! Thanks. -Mike
  5. Ford / New Holland
    I recently became the owner of a 1955 Ford 850, which was left behind by the previous property owner. My issue is with the three point hitch. With the draft control lever in either the up or down position the hitch does not work. However, if I hold the draft control lever at the half way point...
1-5 of 5 Results