Tractor Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-12 of 12 Results
  1. Ford / New Holland
    I have a 1970 Ford 3000 I purchased a several months ago. As the title states, the tractor has no power steering when making right turns. Upon purchasing I replaced the filter in the power steering pump and the steering shaft seal, as fluid was pouring out of the steering column. I only went...
  2. Repair & Technical Discussion
    I've just completed a clutch, Sherman combo, and both hydraulic filters replacement/repair on a 1966 Ford 2000. It was also seized and had a stuck exhaust valve when I got it back in November. Now it's back to gather and running pretty good. There is what looks an exhaust clamp dangling on...
  3. Repair & Technical Discussion
    So you guys have been a lot of help so far so I thought I would come back and ask for a little bit more help. I replaced all the fluids in the tractor this weekend. Prior to doing that the hydraulics worked just fine. After putting the equivalent of what the owners manual says to put in there...
  4. Introductions
    Good Day, I have recently purchased a Ford 2000. I believe it is an early 60's model because it is a gasser, not diesel. I have been trying to figure out how to find the serial number so I can get the year dialed in. It cam with a Davis front loader that I believe was intended for an older...
  5. Introductions
    I have a Ford 2000 gas 3 cylinder, with a hydraulic problem. Seems simple I just can't understand why, from the pump the 1/2" line that goes thru the compression nut, when the tractor is running that 1/2" line comes plum out of the pump, oil goes everywhere. Of course I bought a new compression...
  6. Repair & Technical Discussion
    When brush cutting the PTO lever will pop forward and disengage output to drive the blades. It’s more likely to occur when the blades are under a heavier load. What is this a symptom of? What should I check for? Thanks Pete
  7. Introductions
    Hi, my name is Wayne. I stumbled across this forum while searching the Internet looking for an answer to my tractor problem. I guess I should have just searched "Tractor Forum" first and saved some time. At any rate I am glad I found this sight. I'm an IT professional during the week and...
  8. Repair & Technical Discussion
    Hey- I have a Ford 2000 unsure of the year but it is a later model with the 3 vents on each side of the hood. Gas engine. I won't get into it, but the ignition was left in the on position for an extended period of time and when I went to start it it was dead. Pulled my truck over and...
  9. Ford / New Holland
    It seems it was lucky that I went through all the systems on my (working) tractor and among other things, changed out the fluid in the transmission and rear end/hydraulic sump before the condensation loaded fluid ruined something. Throughout the summer, I used the hydraulics for post hole...
  10. Ford / New Holland
    Hello All, I have a recently acquired 1970 Ford 3000 with manual steering that has a steering problem. The steering wheel started rising and falling (screwing in and out) and I can no longer steer left at all. From information I've seen on this site and others, I think the problem is a broken...
  11. Ford / New Holland
    Hello everyone: I was down shifting the other day from 5 to 4 when the SOS appeared to let go. The handle moves freely up and down with no feeling of detents. I think I have either busted a cable or the cable has become detached. I will take apart the SOS assembly (maybe it just detached...
  12. Tractors
    This is a scan PDF for the Ford 2000/3000/4000/5000 Operators Service Manual
1-12 of 12 Results
Top