Tractor Forum banner

fel

  1. Repair & Technical Discussion
    Main Parts List Hydraulic Pump Drive Coupler, 708639M91, $70 Pump Drive Shaft Assembly, 707166M92, $135 19 GPM SAE-B 13 spline counter-clockwise rotation Hydraulic Pump, HGP AL13S-B02-220L, $172 Hydraulic Filter Assembly, 1042326M1, $34 Various hydraulic fittings, adapters, and hoses We...
  2. Repair & Technical Discussion
    Hello, I have a FEL(LA481) that won't hold it's tilt. When I fully curl the bucket back, it will slowly start to dump. Once it gets past a certain point it will dump rapidly. I think I have narrowed it down to a control valve(B00101) and not a cylinder issue. After swapping the hoses around on...
  3. John Deere
    I replaced the two big O-rings on both ends and replaced the "cup leather"- I still have the "Wiper Seal" and a smaller O-ring that is supposed to go on the rod end of the cylinder. I can't figure out how to uninstall the old ones to put these in! Anyone have any advice? There are what appear...
  4. Ford / New Holland
    Last fall I bought a 2005 NH TL90 with a 52LB loader using joystick control. I used the tractor brush hogging for several hours this fall with the attachment plate off the front of the loader (long story). During that time the loader boom seemingly worked normally. I'm not sure of the last time...
  5. Ford / New Holland
    I am hoping that this video can help out others that may have the same problem that I did. I posted a YouTube video this evening explaining everything in detail. I found out that the only reason everything was gushing out of my lid was because of one wrong oring for my hydraulic sump return...
  6. Classifieds
    2007 Kubota B7800HSD-F Compact Tractor 137+ Hours 30HP, 4-cyl diesel 4WD 60" Front End Loader (FEL #LA402) 16 ft. 10K Dual-Axle Trailer NEW tires, brake controller, LEDs, Chains IM502 60" Bush Hog *Separate Pricing Available Tractor UPGRADES: Piranha Tooth Bar Pat's easy change...
  7. Buying & Pricing
    Hello. I'm considering getting a Quicke loader and would like opinions on that brand, and also which model might be a good match for my Kubota MX5100F tractor (2-wheel drive, 50HP, 44 at PTO, about 70" wide x 128" long, weighs about 3400 lbs., and 9.5 gpm pump capacity in case that helps). I...
  8. Kubota
    So, I've got 5.5 hours on my new L4060 HST and the FEL is causing some problems. I had to wonder if anyone else experienced this. Any help would be appreciated. When I took delivery, the machine worked fine, FEL and backhoe worked as they should. the following week, I went to camp started the...
  9. Kubota
    Hey, everybody. I recently got a Kubota MX5100F (2-wheel drive) that came without a front end loader. I've decided I really would like to have a loader and bucket. What options do I have for loaders? I've seen LA844 and LA854 as being probably compatible/standard, and also LA1065 was mentioned...
Top