Tractor Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Massey Harris-Ferguson
    Good evening all, While getting the MF240 back up and running found the power steering pump was very low on fluid. Topped it up and the right-side steering cylinder displayed a pretty serious leak. Removed both cylinders and took them to local hydraulic shop for rebuild. Right cylinder still...
  2. Long / Farmtrac / Montana/ LS
    I just recently replaced one of my hydraulic lines and was hoping to have the air bleed out on its own while operating with no load. Well, it didn't quite happen like that. Seems like the hydraulic oil level went too low on an incline and I got air in my circuits. I still have most of my...
  3. John Deere
    I replaced the two big O-rings on both ends and replaced the "cup leather"- I still have the "Wiper Seal" and a smaller O-ring that is supposed to go on the rod end of the cylinder. I can't figure out how to uninstall the old ones to put these in! Anyone have any advice? There are what appear...
  4. Kubota
    I have a Kubota L245DT with the 1200 series front end loader, and I need to replace the seals on one of the bucket control cylinders. The part # for the seal repair kit is 2-2857. So far I've been unable to find a kit via Amazon, Ebay, and a general Google search. It's currently a Sunday so I...
  5. Repair & Technical Discussion
    I am having a problem find the proper torque for the (4)cap screws #48 in diagram attached and the castellated nut #23 in diagram attached for the valve spool bolt #35 in diagram attached. The Spec sheet attached is not clear.
  6. Repair & Technical Discussion
    Hello again, Working on trying to stop P.S fluid from leaking all over the ground by rebuilding my Ford 4000 power steering ram(cylinder) and found a couple interesting things. 1st thing is that the main cylinder case has a small hole that looks like a valve pin should go there but looks like...
1-6 of 6 Results