Tractor Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Repair & Technical Discussion
    On an old mower (F525) I am replacing the old carburetor and it has a backfire solenoid valve, but it was broke and I tossed it in the garbage. I got a new carburetor to replace the old one and saw that the bowl plug (where the backfire solenoid screws into the bowl) has a needle valve attached...
  2. Repair & Technical Discussion
    I’ve had some problems getting my 52 8N to start reliably. I finally narrowed it down to the fuel. Not getting any in the carb (MS tsx 33). When I open the drain valve at the bottom of the carb, nothing comes out. Glass bowl is fine, line to carb is fine, and carb inlet brand new. If line is...
  3. Husqvarna
    Hi, I've got a Husqvarna LGT2654 that won't Fire. I got it from a family member for free and trying to get it work. So far, its had a tune up but won't fire, does crank. Does get gas to carb too. Would the Vent Line from the tank, stop it from fireing? Any help much appreciated. Now it...
  4. Repair & Technical Discussion
    This post has moved to the Bolens category
  5. Repair & Technical Discussion
    I have a 1963 international 3414 loader backhoe with a 4 cylinder gas engine. I need a carburetor. Anybody got one. Will any if the carbs tractor supply sells work on it?
  6. General Lawn Garden Tractor Forum
    Asking for some knowledgeable assistance on my Kohler CH18 engine. Installed this replacement some years ago on an ancient Yazoo 60 inch mower. Has run like a champ every year til this one. Began hesitating, surging, governor hunting, etc. It is now to the point that I can start it, but it...
  7. Case / Farmall - International Harvester
    Have to rebuild my carb on the Super H. Are the kits from Case/IH good ? :confused:
1-7 of 7 Results
Top