Tractor Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Case / Farmall - International Harvester
    I recently purchased a new carb for a 1972 Farmall Cub. The tractor runs fine at idle but when you rev the engine it dies as if its starving for gas. Also when you shut it off the carb drips gas as if the needle isn't shutting off the flow. Anyone have any suggestions?
  2. Repair & Technical Discussion
    Hello, I have a IH 2400A front end loader. 1972 ish. I have serial numbers for all. It died on me suddenly. I've replace points cap rotor plus wires coil fuel pump carb rebuild kit but now it is just running to rich or to lean. How can one thing starting out to be electrical end up now with...
  3. Repair & Technical Discussion
    I’ve had some problems getting my 52 8N to start reliably. I finally narrowed it down to the fuel. Not getting any in the carb (MS tsx 33). When I open the drain valve at the bottom of the carb, nothing comes out. Glass bowl is fine, line to carb is fine, and carb inlet brand new. If line is...
  4. Repair & Technical Discussion
    I have a 1963 international 3414 loader backhoe with a 4 cylinder gas engine. I need a carburetor. Anybody got one. Will any if the carbs tractor supply sells work on it?
  5. Repair & Technical Discussion
    I'll try not to get lengthy here. Was given a 1996 Craftsman lawn tractor. Briggs 19HP opposed twin. Wasn't getting fuel so cleaned the tank with boiling water, replaced the hoses, filter, and rebuilt the fuel pump. Still wouldn't start. Pulled the top of the carb off, filled the float bowl...
  6. Projects
    I would like to know if I can put a flywheel with pull start from a 12hp B & S 281707 0028 88* engine to a similar non pull start engine 281707 0411 90*. What other parts might need to be changed over? Any other problems that I might find? Similarly can I swap the whole carb which has...
1-6 of 6 Results
Top