Tractor Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Ford 9N/2N/8N
    I rebuilt the hydraulic pump on my 9n due to weak lift. After investigatin I found leaks at the top of the valve chambers. I assumed that was the issue so I got a full rebuild kit. Brand new pre assembled valve chambers/ pistons. New relief and control valve. After much struggling with getting...
  2. Introductions
    Hi and thanks for having me, I recently started working on 3 antique tractors, a 1946 Ford 8N with a loader and backhoe (Sherman i think) attachments, a 1943 Ford F9 that we will be converting to all Electric, and the current problem child, we believe its a 1963 Case 420B wheel backhoe loader...
  3. Ford 9N/2N/8N
    Every one i look at is different than mine. S/n tells me 9N. But when I look the part up (several different places) it isn't like this one. I realize the angle iron scabbed on there isn't original but the middle is different too any insights are appreciated. Thank you
  4. Repair & Technical Discussion
    .So i bought a 48 9N with no oil pressure guy said he parked it right away but it rattles pretty bad. With the tractor i got aother engine he said it was from a model a and had approx 15,000 mi. On it. Said it was the same engine. Getting started on the engine swap and looking closer at the two...
  5. Repair & Technical Discussion
    My clutch was stuck on my 41 9n. I replaced it the pressure plate, pilot bearing and throwout bearing. Now the it feels like the throwout bearing isn't making contact with the pressure plate at all. Could I have messed up something? Any help is appreciated!
  6. Repair & Technical Discussion
    My ‘42 9N is backfiring like crazy. And I have no power under any load, even going up a small incline. I have done the following Converted to 12 volt system Replaced cap, rotor, points, plug wires and plugs I have reset the timing spot. I know i have screwed up somewhere but not sure where to...
  7. Ford 9N/2N/8N
    Howdy folks, I recently bought a 1942 9n. It was original 6 volt system. Ran like a charm. Then I converted to a new 12 volt system. Bought the upgrade kit and installed new 12 volt coil, new alternator, new wiring now when I attach the positive battery cable after the negative battery cable, it...
1-7 of 7 Results
Top