Tractor Forum banner
8n
1-5 of 5 Results
  1. Repair & Technical Discussion
    I have a 64 Ford 4000 4 cylinder gasser I’ve been fooling with. I’m having problems with intermittent spark. I’ve replaced coil, points, rotor, plugs and wires. When the cap is off I usually only get spark between the points after letting go of the starter button. When holding a plug to the...
  2. Ford 9N/2N/8N
    Hello, my name's Davey and i just bought an old Ford 8N tractor. When the man brought it to me, he showed me it was running great. He cut it off and started it several times and it started and ran great every time. Next day i went out to start it and flooded it. I tried to start it again a while...
  3. Ford 9N/2N/8N
    Hello, I'm new to the forum so hopefully I'm posting this in the right spot. If not please don't throw tomatoes. Brought my 8N into the shop to get it running better and decided it would run way better with a new steering wheel - 15min job, no problem. Two hours later and every tool in the...
  4. Repair & Technical Discussion
    Hello all, I have already watched the videos available for replacing the clutch and it does not seem that difficult. However, I have yet to find exactly what else that I should replace while the tractor is split apart. I did find mention of transmission seal on an earlier post, but when I...
  5. Ford 9N/2N/8N
    Hi everyone, I have a ~1950 8N that I only operate during the summer; it hasn't had many problems before. This year, it won't go when the PTO is engaged. Whether its in 1st or reverse, the engine sputters and dies when I release the clutch. Does anyone have any experience with implements...
1-5 of 5 Results
Top