Tractor Forum banner
3 point
1-8 of 8 Results
  1. Repair & Technical Discussion
    Hi I have a David Brown tractor 880 Selectematic mid to late 60's The 3 point linkage will not lift if the tractor is pointing down hill at all, even on a slight slope. I've had a suggestion from a person on the forum that the tractor may possibly have the wrong transmission dipstick hence the...
  2. Repair & Technical Discussion
    I recently acquired a 1973 Case 446 with deck & blower. I'm looking to either sell/trade for a tractor with the attachments I need or restore this one and buy 3 point and PTO set up. My question is, is there a one stop shop for all the parts I need? Or, is there any interest in buying it trading...
  3. Repair & Technical Discussion
    Hi - I have a 1977 IHI Shibaura sd4000a 2 wheel drive. The hydraulic arm is going up but won't stay up when I disengage the drive. I think the hydraulics and gears have the same oil top up. When checking the level it is good but creamy white. I want to drain it and refill but am not sure which...
  4. Allis Chalmers
    I have an Allis Chalmers 160 that has no resistance on the three point lift lever. It raises and lowers but when I turn loose of the handle the 3 point drops and the lever drops to the bottom of the quadrant. I don't see anything on the outside that might allow me to tighten to add resistance to...
  5. Kubota
    I have a Kubota m105x and the 3 point lift is inop , sometimes it will work from the rear buttons but never from inside, when I move the switch inside the light lights up that it is seeing my request, but most of the time it just flashes fast all the time and nothing works, fuses good . Any help...
  6. Ford / New Holland
    Hi there im thinking about purchasing a single spool valve kit for my Ford 4000. I still have the original switch on the tractor for the single pipe. When I pull out the switch the 3 point arms lock in place and I use this when pulling a trailer to keep the linkage arms up high. I am wondering...
  7. Ford / New Holland
    Guys, I was on here about a year and a half ago and rebuilt the engine on my 72 Ford 3000 Gasser all the way through. It was successful thanks to alot of hard work and advice from you guys. Now it's time for the rear of this tractor. After getting it running I noticed the 3point is very...
  8. Chinese / Grey Market Tractors
    Hello all, I have this Farmpro 2420 tractor and recently rebuilt the hydraulic lift and replaced the hydraulic filter under the seat, hoping to address a slow drop issue. I still have this very slow drop when an implement is attached. I have the adjustment screw in as far as I can without...
1-8 of 8 Results
Top