Removing Steering Gear Box Ford 3000

Discussion in 'Ford / New Holland' started by TimMiller, Sep 15, 2007.

  1. TimMiller

    TimMiller New Member

    Sep 15, 2007
    I'm trying to remove the steering gear box on a ford 3000 tractor. I have everything off except i cannot figure out how to get the linkage that goes from the steering wheel to the steering box off so i can remove the steering box. Thanks
  2. cbumdumb

    cbumdumb New Member

    Sep 24, 2007
    I hope I understand your question right to remove the box you have to remove the steering wheel and the rear cowling and fuel tank. the tube and shaft come out once you remove the sector shaft .

  3. TimMiller

    TimMiller New Member

    Sep 15, 2007
    I wasnt sure if there was a way to leave the tube and shaft in the tractor and just remove the gear box. But from what i'm told it all has to come out. Also, where can i get a steering box rebuild kit? Or is there even one available, or do i have to piece everything together?
  4. kd5rcx

    kd5rcx New Member

    Sep 22, 2012
    Are there not any kits? If not what parts need to be replaced? And should we try #00 grease first? In my case it's hard steering, but one way is harder than the other.