cyrush

LATEST ACTIVITY

• Posted in thread: Battery specs for a B414 on 04/02/2012 at 3:53PM
  When they were built , CA or CCA were not mentioned as part of battery specs ?????Suggest you measure
  battery box and make a note of terminal layout , then talk to battery supplier to find largest cap...

• Posted in thread: International 484 Hydraulic filter on 03/29/2012 at 3:10PM
  Look under the L/hand rear wheel , you wil find a filter bowl on a valve block bolted to the vertical
  side of the transmission. When you remove the centre bolt it will reveal a paper element and metal...

• Posted in thread: IH-434 Glo-Plug issue on 03/23/2012 at 5:29PM
  You cant miss them , on l/hand side just below injectors, connected together by the copper current wires.
  ``the knurled nuts holding the wires on are i think ally ??

• Posted in thread: IH 656 Hydrostat/Hydraulics died on 03/20/2012 at 4:14PM
  Glad to hear you eventually got it back ??? Best of luck !!

• Posted in thread: IH-434 Glo-Plug issue on 03/20/2012 at 4:11PM
  Replacement of glow plugs was never documented in any IH manuals ???Carefully remove the connecting
  wires, noting position and type of any spacers / washers, treat plug stems to an anti seize fluid, w...

• Posted in thread: B414 on 03/14/2012 at 7:15PM
  Service manual (IH) specifies the engine lubrication relief valve as having a setting of 30 - 35 PSI.

• Posted in thread: CDU cant read CPU on 03/14/2012 at 7:04PM
  Dont know what diagnostic socket you have on tractor but they are usually multi pin with a 12volt (-) &
  (+) supply, the (+) is usually fused ?? Other problem may be a blown can bus terminator diode on...

• Posted in thread: International Harvester 584 Decals on 03/08/2012 at 3:37PM
  See att it lists what you need by part no.Go to messicks site (They advertise on this forum) & see what
  is available.If not available from them try some of the advertisers in the vintage tractor magaz...

• Posted in thread: Farmall 806 oil leak on 03/06/2012 at 2:38PM
  If theres a bad injector you can usually hear it in the exhaust note as a miss fire ??, and loosening one
  injector feed pipe a little, with the engine running will find the bad injector.Usual causes a...

• Posted in thread: Farmall 806 oil leak on 03/06/2012 at 2:34AM
  So the engine oil level instead of dropping with the leak has stayed the sam or has risen. ??????????