OneWelder

LATEST ACTIVITY

• Posted in thread: My Jinma Broke in Half!! on 03/13/2009 at 6:10PM
  quite often you can see a casting flaw- study the grain,also look for a place that is a lot thinner

• Posted in thread: Disc Will Not Disc on 03/12/2009 at 2:32PM
  SOMETIMES you can run the disks parallel. They will penetrate deeper than go back with them at angle -
  also try harrowing in a figure 8 pattern- if this works you would not have to buy a plow- depends...

• Posted in thread: 8N catastrophe? on 02/02/2009 at 8:04PM
  I can not guarantee nothing will happen - But I have split 8n s and found two broken drives in there- my
  brother just split his and said he found three - I do not know if he was kidding me or not.

• Posted in thread: front mounted snow plow for 2n ford on 08/18/2008 at 1:28PM
  Should be two triangled shaped brackets with pulleys- these are guides that bolt to ft axle cable runs
  from under plow fram through pulleys to back of machine and attaches to 3pt hitch for rasing and ...

• Posted in thread: IH 784- help please! on 05/07/2008 at 5:35PM
  In looking this over I see I can not spell PROBABLY

• Posted in thread: IH 784- help please! on 05/07/2008 at 5:31PM
  Since nobody replied to you I Can guess, and that is all it is.It will probaly be a 6 cyl. diesel of the
  282 family- These take a lot of glow plug to start- It will probaly have a "Hydro" trans. If it...

• Posted in thread: hydralics on 05/06/2008 at 5:18PM
  I would Change the the safety valve (Relief ) cost less then 30 bucks and are troublesome - also take
  side cover off and with pump running look for oil stream , sometimes the pipe to cyl. splits - if ...