MFreund

LATEST ACTIVITY

• Posted in thread: How to get rid of these vines? on 10/24/2010 at 2:09PM
  Cut the shoots off close to the ground and paint the stem with Brush-B-Gone.

• Posted in thread: Body plastic repair ? on 09/20/2010 at 9:25AM
  I found this on another tractor site for the same question.It's a soybean / corn ethanol polymer made for Deere by Ashland Composite Polymers division of Ashland Oil. The trade name is ENVIREZ. The pr...

• Posted in thread: Poor clipping discharge on 09/20/2010 at 9:18AM
  Your grass is too long to efficently use mulching blades. Mow more often or remove the discharge block.

• Posted in thread: New vs Old on 09/20/2010 at 9:13AM
  I would never give up fuel injection and hydro for carbs and gears. For me that rules out the old. I am however, not against looking for good used. If you want to find a good used you need to do the h...

• Posted in thread: X595 cutting out on 09/12/2010 at 5:28PM
  Have you checked or tried to bypass the seat switch? Try puting a jumper wire at the seat swich connection. If it does not cut out replace the seat switch. If you come off the seat with PTO engaged it...

• Posted in thread: Jd 3130 ls on 09/12/2010 at 5:19PM
  I checked here TractorData.com - John Deere tractors sorted by modelIt was not listed. I would pass as it may be very hard to get replacement parts. If you could find a tractor sold here that was the ...

• Posted in thread: New Owner Of John Deere 316--Questions... on 08/29/2010 at 8:30PM
  You should try to adjust the pto clutch. The spec is .020 but many people adjust it down to .015- .018, as the clutch wears the air gap gets too large and causes the clutch to disengage. Adjust the ai...

• Posted in thread: Farm Progress Show/Tractor show on 08/16/2010 at 10:07AM
  Are you guys getting cleaned up after the flooding last week? I am going to try to make it, but I work nights and would have to take two days off to make it. We will see.

• Posted in thread: 2004 John Deere 4310, 2004 - Questions on 08/02/2010 at 1:58PM
  you have broken spring. Part # 23 I thinkJohn Deere - Parts Catalog

• Posted in thread: 4310 Lamp Indicator on 06/02/2010 at 7:29PM
  It comes up as a code for the valve output to forward or reverse coil. The calcuated value for the coil resistance exceeds tthe valid range due to open or short.The first thing I would do is crawl und...