Leon

LATEST ACTIVITY

• Posted in thread: L2500DT oil pan removal on 08/04/2009 at 12:49PM
  I just worked on a L2950 and I'm hoping for your sake that it is the same.Disconnect the bolt that is
  holding the hollow tube to the oil pan. On the rear side of the drive shaft there is a roll pin th...

• Posted in thread: Learniing on a WD on 08/02/2009 at 9:31PM
  The engine. Without power the rest of the tractor is useless. Start by trying to get it unstuck.-Leon

• Posted in thread: 3 point HELP!! on 07/30/2009 at 10:14AM
  If you can visibly see oil leaking from the piston while the 3 point is up and has a load on it, then
  yes, honing and re-ringing it will help the dropping if that is the only problem. According to the...

• Posted in thread: 6v/12v ? on 07/30/2009 at 10:04AM
  If you get one of these:8N front mount distributor: Side mount distributor: will get everything you
  need to convert to 12 volt minus the battery.If you just put a 12 volt battery in there you will...

• Posted in thread: hydrolic guestion on 07/22/2009 at 10:06PM
  That sounds about right. Check to see if the top link rocker moves back and forth or if it's stuck to the
  rear end housing. Also check to see if you can rotate the large spring by hand or not. If you ...

• Posted in thread: runs fine cold, hiccups when hot on 07/21/2009 at 1:44PM
  I vote for fuel restriction. Pull the pipe plug out of the bottom of the carb and see if you get a
  constant supply of fuel or if it guzzles out and then slows to a trickle. Install/replace the plug a ...

• Posted in thread: hydrolic guestion on 07/21/2009 at 1:36PM
  Try your procedure again with both tractors, but this time do not attach the top link, only the 2 lower
  arms. Let us know if anything changes.-Leon

• Posted in thread: Jd F525 on 07/20/2009 at 8:55AM
  According to my online John Deere dealer all the parts are still available, they are just not listed
  under the kit part number anymore. Total cost should run you about $150.00. in F525 under model-Le...

• Posted in thread: international 574 powered steering problems on 07/16/2009 at 11:22PM
  I hope you have good luck with it by changing the oils and filters. The usual cause for warm tractor
  hydraulics not working is a worn out pump, unfortunately. But that can be tested if it comes to tha...

• Posted in thread: Help with connecting 3pt brush hog on 07/16/2009 at 11:17PM
  It's not supposed to reach, it appears you don't have a top link. Get yourself one of these bad boys: